Apex Digital apex 10 Manual de servicio descargar pdf (Pagina 106)

108 APEX — Installation and Service Manual

Section 3 — Installation

As described on S34-1/2 – Stereo/Mono Mode Selection on page 94, Apex is

normally set for two-level stereo operation; this allows for stereo mode

switching such as mix, reverse, etc. In this mode the Apex boards are

programmed so that the right channel is always 4 physical level

numbers higher than the left channel. In the case of Jupiter control, the

router would have a two-row entry in the Switcher Description table,

e.g., one for a 256 x 256 Left level (typically Level 32 as described above)

and one for a 256 x 256 Right level (typically Level 36).

Switcher protocol (driver) type is binary.

Note Apex connector numbering is 1 based whereas Jupiter physical input/output

tables are 0 based. This means, for example, that physical input number 0 on

the Jupiter Switcher Input table represents input connector number 1 on the

rear of the Apex chassis.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 133 134

Sin comentarios

Apex Digital apex 10 Manual de servicio Pagina 106